An Australian liquid fertiliser manufacturer needed to transfer acidic fertiliser between several locations at its facility. The customer also requested self-priming operation as an operational safety measure.
Global Pumps supplied a Techniflo 403PW-N.CV self-priming magnetic drive centrifugal pump with polypropylene wetted parts, mounted on a stainless-steel trolley. The unit was supplied ready to run, with its own starter and a plug for a standard 15 A outlet.

The challenge: A chemical pump for different locations
The customer needed one portable pumping system that could be moved between several transfer points across the facility. A permanently installed pump was therefore not suitable for the application.
The liquid being transferred was acidic fertiliser, so the pump materials had to be compatible with the chemical duty. The customer also requested self-priming operation as an operational safety measure after its previous pump ran dry and failed.
The pump needed to deliver a flow rate of 200 to 400 litres per minute (L/min). Together, these requirements shaped the selection of the pump, materials and mobile trolley package.
The solution: A portable, self-priming pump package
Global Pumps supplied a Techniflo 403PW-N.CV self-priming magnetic drive centrifugal pump on a stainless-steel wheelbarrow-style trolley. The package was selected for acidic fertiliser transfer and the customer’s required flow range of 200 to 400 L/min.
Materials selected for the chemical duty
The pump combines polypropylene wetted components, a Viton O-ring, a ceramic shaft and a carbon bearing. Its magnetic drive transmits power to the impeller without a mechanical shaft seal, removing one potential leakage and maintenance point.
Chemical compatibility remains dependent on the fertiliser’s composition, concentration and temperature, including the compatibility of the system’s gaskets and connections.
How the self-priming design works
The built-in self-priming chamber separates air from liquid, allowing the pump to clear air from the suction line and establish flow under suitable operating conditions. This capability met the customer’s requirement for self-priming operation, with initial filling and operation carried out according to the manufacturer’s instructions.
Built for movement and straightforward operation
The supplied package includes a 2.2 kW single-phase motor, an impeller trimmed to 142 mm, a stop/start switch and a direct-on-line starter with overload protection. It can be connected to a standard 15 A power outlet for straightforward operation around the facility.
The stainless-steel trolley provides mobility between transfer points, while 2-inch camlock connections make connecting and disconnecting the suction and discharge hoses easier.
The result: One mobile chemical transfer unit
The completed trolley-mounted unit combines self-priming capability, a seal-less magnetic drive and site mobility for the customer’s acidic fertiliser transfer application.
The customer can move one pump package between several locations instead of relying on a permanently installed pump at each transfer point.
Discuss your chemical transfer requirements
If you need to transfer corrosive liquids between locations, speak to Global Pumps about your fluid, required flow and head, suction arrangement and available power supply.
Our team can assess your application requirements and recommend a suitable solution for your site. Contact Global Pumps.


